Thanks for the great program!
I seem to have problems with input pins when I orientate them to the top and bottom. It doesn't seem to make the proper connections to the gates. It works fine when they are on the left. Is there something I am doing wrong?
Thanks,
Bill
Input pin problem
Re: Input pin problem
Hi Bill,
There are could be either a bug in the program or you did not actually connected wire to pin.
Please do the following: click the wire that is not working properly and see if it ends at the right places. If it is drawn correctly, then please save this file and send to me. You can attach it here on the forum, or send me email.
Another possible reason is the pin is not connected inside the circuit so please check this too.
Thanks,
Eugene
There are could be either a bug in the program or you did not actually connected wire to pin.
Please do the following: click the wire that is not working properly and see if it ends at the right places. If it is drawn correctly, then please save this file and send to me. You can attach it here on the forum, or send me email.
Another possible reason is the pin is not connected inside the circuit so please check this too.
Thanks,
Eugene
Re: Input pin problem
Hi Eugene,
I tried it again and it worked. Sorry to bother you over a mistake that I must of made.
Thanks,
Bill
I tried it again and it worked. Sorry to bother you over a mistake that I must of made.
Thanks,
Bill