Hi,
I am new here and try using the LogicCircuit program.
One of my problems:
In many cases when I want to draw a wire to an existing wire, the connection point is missing on the "T"-shaped connection.
In some other cases LogicCircuit sets the point automatically.
No combination of mouse click and shift, alt or ctrl helps settimg the connection proint.
Who can help?
Dietrich
Connecting wires
Re: Connecting wires
Hi Dietrich,
If you select a wire and click it while holding Alt key on your keyboard then the wire will be split at the point of click. So if you don’t see a connection point at T – shaped just split the top wire.
You can read more about mouse and keyboard gestures at help section: http://logiccircuit.org/help.html
Thanks,
Eugene
If you select a wire and click it while holding Alt key on your keyboard then the wire will be split at the point of click. So if you don’t see a connection point at T – shaped just split the top wire.
You can read more about mouse and keyboard gestures at help section: http://logiccircuit.org/help.html
Thanks,
Eugene
Re: Connecting wires
Thank you very much!
Your hint works perfectly.
Dietrich
Your hint works perfectly.
Dietrich