However, the last question is to build this sequential logic circuit on a breadboard, and so far nothing is happening ,the LED TLHB4201 doesn't light up(http://www.kynix.com/Detail/3877/TLHB4201.html):
simulate this circuit – Schematic created using CircuitLab
For the above schematic, Node 1 and Node 2 are inputs (either 0 or 1 depending on whether a switch button is pressed) and Node 3 is the output, which is an LED (so presumably it should light up on some kind of combination of inputs).
My NOR gate (which works correctly) is wired up like this:
transistor 1 left: gnd
transistor 1 middle: switch > 10k resistor > 5v
transistor 1 right: connected to the right of transistor 2; connected to 1K resistor then 5V; connected to LED then gnd
transistor 2 left: gnd
transistor 2 middle: switch > 10k resistor > 5v
transistor 2 right: connected to the right of transistor 1
I then made two NOR gates which I need to modify to make the sequential logic diagram above. Right now I have it wired like this, but it's NOT working:
NOR gate 1:
transistor 1 left: gnd
transistor 1 middle: switch > 10k resistor > 5v
transistor 1 right: connected to the right of transistor 2; connected to 1K resistor then 5V; connected to LED then gnd; connected to NOR gate 2 transistor 2 in the middle
transistor 2 left: gnd
transistor 2 middle: connected to NOR gate 2, transistor 1 right
transistor 2 right: connected to the right of transistor 1
NOR gate 2:
transistor 1 left: gnd
transistor 1 middle: switch > 10k resistor > 5v
transistor 1 right: connected to the right of transistor 2; connected to 1K resistor then 5V; connected to NOR gate 1 transistor 2 in the middle
transistor 2 left: gnd
transistor 2 middle: connected to NOR gate 1, transistor 1 right
transistor 2 right: connected to the right of transistor 1
If none of my description makes any sense, can someone just tell me what the expected output for the LED should be? I have two switches, so I can put in 00, 01, 10, and 11 as inputs. What should happen to the LED in those cases?
Edit: Here's my best attempt at a schematic for the sequential logic circuit. Transistors may be flipped around, not sure, but the sides I picked should be consistent (I know which side is which on my breadboard.)
simulate this circuit
simulate this circuit
Tidy-up of schematic edited in by @transistor. I have assumed transistors C and E were reversed in each case.