Project Snake

[superryan94]

Thanks for your time on solving the issues. Unfortunately after a test run I noticed that one of my circuits is still oscillating. However, now I can't predict when it will oscillate. I did 3 runs and all 3 had a different score when it happened. First at 1750, second at 1000 and the last at 2500.Can you look if it isn't just a problem with my circuit instead of the program. Because I don't have any kind of study in the direction of this I can have easily made a mistake.

I made a nice arrow pointing at the suspect of the problem.

[superryan94]

It's been quite some time since I worked on my snake project.
I just started again and after figuring out how it worked(remembered it to be easier:/) I found something funny.
I wanted to get a signal from point A to point B it's not connected but does activate a LED
https://prnt.sc/jj8hsy

The signal starts in main screen at the button:"Start"
Than goes to the end where it meets an or but is not connected to..?
That or gate is found in:Main screen\Row 3\Screen Block 3.2\Screen Control Circuit 2\Snake Mover Board 2\Snake Mover Circuit With Starter.
There are a few LED's to find the signal.
The LED's light up but the wire going there says not connected.
Can you see what I did wrong here?

BTW, I started with following the cable but there are no open spots in the line.

[Xaetral]

it comes from your block called "left wall"