Page 2 of 3
Re: My first circuit: 74155
Posted: Fri May 04, 2018 3:48 pm
by Prof_Magnesium
I am enjoying a lot LogicCircuit. Here are more 3 ICs I have mounted.
The attachment IC74253.CircuitProject is no longer available
The attachment IC74257.CircuitProject is no longer available
Re: My first circuit: 74155
Posted: Fri May 04, 2018 3:49 pm
by Prof_Magnesium
Re: My first circuit: 74155
Posted: Fri May 04, 2018 3:51 pm
by Prof_Magnesium
Re: My first circuit: 74155
Posted: Sat May 05, 2018 8:38 am
by Prof_Magnesium
Adding more 3 CIs.
The attachment IC74241.CircuitProject is no longer available
The attachment IC74192.CircuitProject is no longer available
Re: My first circuit: 74155
Posted: Sat May 05, 2018 8:39 am
by Prof_Magnesium
Re: My first circuit: 74155
Posted: Sat May 05, 2018 8:40 am
by Prof_Magnesium
Re: My first circuit: 74155
Posted: Sat May 05, 2018 9:06 pm
by Prof_Magnesium
I tried to simulate the 74122 and 74123 one-shot CIs. I used the ideia of counting a number of periods of the clock. My project has an 8-bit counter which resets a D flip-flop when the count is equal to the preset value. This value is informed with two nibbles (2 x 4 bits) specific to each one-shot circuit. This mean that it replaces the R-C analogue delay. However I have some doubts about the validity of the method:
(1) which factors define the clock frequency?
(2) the clock I put in one timer circuit is the same for the whole simulation, or independent?
Finally I think that it would be interesting to introduce an analogue part in LogicCircuit to simulate these one-shot circuits, for instance, such as a R-C element that could be charged with a high level applied to it, combined with Schmidt triggers, for example.
Re: My first circuit: 74155
Posted: Wed May 09, 2018 1:04 pm
by Prof_Magnesium
Going on: one more 74xxx. I should stop now because I have now all the TTL IC I needs to simulate my 8-bit computer.
The attachment IC74170.CircuitProject is no longer available
I started to build RAM and ROM. To load the ROM I was surprised by the fact that the data must be stored in binary files. But it was not very difficult to transform ASCII in binary.
The attachment IC_S287.CircuitProject is no longer available
The attachment IC_S288.CircuitProject is no longer available
The attachment IC_2716.CircuitProject is no longer available
Re: My first circuit: 74155
Posted: Wed May 09, 2018 1:05 pm
by Prof_Magnesium
The attachment IC_S287.CircuitProject is no longer available
Re: My first circuit: 74155
Posted: Wed May 09, 2018 1:06 pm
by Prof_Magnesium
I put one file at a time because it doesn't work when I put more than one!