Bug in splitter
Posted: Wed Jun 10, 2015 2:11 pm
There seems to be a bug with the splitters.
I'm sending a 16bit bus into a splitter that should split it into 16 wires of 1 bit each, but it doesn't.
instead i'm getting a mixture of 1 bit and 2 bit busses.
Also as a result of this, the cpu i'm building is sending 11 bits through a 7bit input and output pin which should not be possible.
I have updated to the newes version of the program (2.15.03.24 at time of writing) to see if it would resolve the problem, but it did not.
if this problem is not resolved, i have to postpone the project until it's done, or swap to a new program (which is undesireable).
I'll put the project as a attachment for debuging purposes.
I'm sending a 16bit bus into a splitter that should split it into 16 wires of 1 bit each, but it doesn't.
instead i'm getting a mixture of 1 bit and 2 bit busses.
Also as a result of this, the cpu i'm building is sending 11 bits through a 7bit input and output pin which should not be possible.
I have updated to the newes version of the program (2.15.03.24 at time of writing) to see if it would resolve the problem, but it did not.
if this problem is not resolved, i have to postpone the project until it's done, or swap to a new program (which is undesireable).
I'll put the project as a attachment for debuging purposes.