www.logiccircuit.org

Greetings, how can I sort the pins on the circuits I make ??

On the circuit you just rearrange them from left to right and top to bottom to change position on the symbol.

the problem is that I need to change only the pins not the internal circuitry. Like say that the multiplexer has 01 and the 1 pin needs to open but the arrangement is 10 which is wrong. However the internal is right. Even if I rearrange them the outside box keeps them the same.

If I could click on the object and sort it from outside it would be fine.

It is impossible to manipulate the pins outside, but you can rearrange them inside your circuit. To better see the the pin positions you double click on the pin and provide a short text for notation field. This will appear on the circuit symbol, so it is easier to see where each pins goes.