Would it be possible to:
A. Highlight all connected wires when you click on one with a key pressed, say shift+click?
B. Use thicker lines to draw wires and gates.
I think these would make it much easier to read large pages and to edit wire busses.
Ideas for the editing system
Re: Ideas for the editing system
Hello,
Thank you for suggestions.
You already can shift-click a wire to select all connected ones.
It is really hard to debug big circuits hence I'd recommend to make them small The rule of thumb is you should be able to see the entire circuit in 100% zoom. You have plenty of tools in the programs to do this. Please read help pages at https://logiccircuit.org/help.html for more details on what you can do in the program.
Regards,
Eugene
Thank you for suggestions.
You already can shift-click a wire to select all connected ones.
It is really hard to debug big circuits hence I'd recommend to make them small The rule of thumb is you should be able to see the entire circuit in 100% zoom. You have plenty of tools in the programs to do this. Please read help pages at https://logiccircuit.org/help.html for more details on what you can do in the program.
Regards,
Eugene
-
- Posts: 5
- Joined: Mon Jun 10, 2019 4:58 am
Re: Ideas for the editing system
Thanks for the info on wires! I never knew that was there!
Though it is ironic that I suggested the key that was already in place. Hmm...
Though it is ironic that I suggested the key that was already in place. Hmm...
-
- Posts: 5
- Joined: Mon Jun 10, 2019 4:58 am
Re: Ideas for the editing system
Also, would it be difficult to add a keyboard binding for buttons? Like, when you open the settings for said button, you could select shift and then when power is turned on, the shift key controls that button.